VT-HNC100-1-23W-08-P-0 R900958999 Digital Axis Controller

VT-HNC100-1-23W-08-P-0 R900958999 Digital Axis Controller

VT-HNC100-1-23W-08-P-0 R900958999’s eNet network utilizes a controller-initiated sending mechanism based on multicast technology, whereby the KM940 controller sends out data proactively as it changes. No matter how many operator stations there are, the controller sends data only once.

The main data communication traffic of VT-HNC100-1-23W-08-P-0 R900958999 is the data flow from the controller upstream to the operator station. This design scheme will slightly increase the communication processing load of the operator station, but it can greatly reduce the network load and controller load. In the DCS with 10 full-featured stations, NT6000 network load and controller communication load are 1/10 of the traditional way, while the controller communication load is also 1/10 of the traditional program, and with the increase in the number of operating stations, the network load and controller load is constant. The constant low load brings better task certainty and higher reliability.

The eNet network design of VT-HNC100-1-23W-08-P-0 R900958999 brings low load and reliability, but also greatly improves the speed of network communication, the typical operation response cycle of VT-HNC100-1-23W-08-P-0 R900958999 is less than 700ms, which is much better than the standard 2.5s. The I/O power supply design of VT-HNC100-1-23W-08-P-0 R900958999 adopts two redundant DC power supplies to send to I/O modules. The I/O power supply design of VT-HNC100-1-23W-08-P-0 R900958999 adopts two redundant DC power supplies, both of which are sent to the I/O module, and the two power supplies are switched in the I/O module, which fully realizes hazard dispersion.