T8110B of the upper and lower two lines of digital tubes were to control the cut length and cut the number of rows will be set with blinking indicated, press the “start to determine” key to switch the position of the input. Input numbers can directly modify the corresponding parameters. If there is a mistake during the input process, you can press the “Cancel” key to delete the entered data and return to the display of the original parameters. If the control quantity is set to 100, then

T8110B operation mode:
1-Press the “Control Setting” key to enter the “Control Parameter Setting Status” in the manual state.
2-Press the “Start OK” key to make the lower line display (number of controls) blink.
3 – Key in the following sequence: “1 key”, “0 key”, “0 key”.
4-Press the “Start OK” key to write the entered parameters to the controller. Data setting is completed, press “reset” key to exit the “control parameter” setting state.
5 Press “Clear Quantity” to clear the current number of sheets; press “Clear Length” to clear the current length.