ABB RXPSU6n High Speed Tripping Relay

ABB RXPSU6n High Speed Tripping Relay

ABB RXPSU6n High Speed Tripping Relay – High speed trip relay without operation indicator

Technical Specification of ABB RXPSU6n Tripping Relay

• Type: Electro Mechanical Relay.
• Protection Type: High Speed Tripping Relay.

OTHER HIGH SPEED TRIPPING RELAY RX SERIES

1. RXPSU6n , with 6 free contacts and without operation indicator
2. RXPSU14n with 14 free contacts and operation indicator
3. RXPQ8n

Features

• High degree of reliability, even when it has been idle for a long time
• RXPSU14n is with mechanical flag type indicator
• 6 / 14 contacts with double interruption
• Contact configuration can be changed with ease
• Wide range of voltage and contact configuration

Application

For remote and automatic controls there is often a need for contactors which have two stable contact positions, even in the dead state. This requirement is fulfilled by changeover contactors type RXPSU…n.
The application of alternate control pulses to the coils cause the contacts to change from the one state to the other. If the supply is interrupted, the contacts remain in their previous position, even when the voltage is restored.

Design and principle
The bistable relays in the COMBIFLEX system, type RXPSU6n and RXPSU14n are composed of the same constructional elements as the established contactors type P8n. Two magnet systems are interconnected by a pivoted element. In the type RXPSU6n with 6 free contacts, only one system has contacts; in type RXPSU14n with 14 free
contacts, both systems have contacts. In each case two contacts are required for changing over the connection of the coils.

The contacts are arranged symmetrically on both sides of the relay coil and armature assembly in two stacks. They are easily accessible and the conversion from N/C to N/O contacts and vice versa is simple. The maximum rated voltage is 250V DC or AC and the material used is hard silver. The following definitions apply for reset and operate
condition. Reset condition – Armature assembly position is away from the base i.e. the upper system has been pulsed and lower system is ready to be pulsed. The flag strips are invisible i.e. white during this condition. Operate condition – Armature assembly position is closer to the base i.e. the lower system has been pulsed and upper system is ready to be pulsed. The flag strips are visible i.e. red during this condition.A transparent, incombustible cover with a gasket
protects the contacts against dirt.

The terminals of the contact stacks themselves to permit two wires of 1.5mm diameter maximum to be secured.
Changeover relays must always be mounted with the contact post horizontal, that is with the base on a vertical surface. The plug-in relay module occupies two seats (2U 12C).

Type designation of auxiliary relays

RXPSU:  Basic relay with combiflex mounting.

6n : with 6 free contacts and without operation indicator

14n : with 14 free contacts and operation indicator.