Description
GE T35 Dedicated Controller
The small T35 terminal block wires are routed through a single plug. The travel switch is connected by a white cable, divided into three wires, generally black (or yellow) is the travel common wire, travel switch are connected to the normally open contact (near the swing arm of the two screws). After connecting, move the travel switch by hand, X4 lights up the upper limit position, X3 lights up the lower limit position. Otherwise check or replace. Turn the counter wheel by hand in the direction of the travelling plate, the computer should display the value, if it is negative, change the 3 and 4 of the small wire row (or X5 and X6).
T35 operation:
1 Press “Pump On” to start the oil pump. Note the direction of rotation of the pump motor.
2 Press and hold “Fast Forward” to move the board to the outside of the cutter, press and hold “Lower Knife” to cut off the board, and press and hold “Raise Knife” to raise the knife to the outside of the cutter.
Press and hold “Lower Knife” to cut off the board, and press and hold “Raise Knife” to raise the knife to the upper limit.
3 Press “Control Setting” to set the control length and number of sheets.
E-mail:dcsplcsales@gmail.com
Wechat:+86 13365909307
Phone:+86 13365909307